|
Post by mark4 on Oct 8, 2010 16:36:21 GMT -5
I should know this. What is the size Hex alignment tool. Used for Browning III/IV For browning radios. Broke mine after many years of use. Antique radio has a single one. Think the part number is S-t 9091 .125 not sure. They have a CB kit. i anly need the tool for the tanks in browning radios.
|
|
|
Post by Tombstone (R.I.P.) on Oct 9, 2010 6:54:43 GMT -5
The size of the hex part is a good question. I'm still using an old "pocket protector" kit that has Color TV printed on it. Got it at radio Shack but I doubt if they still have them. I think MCM Electronics in Dayton, Ohio has various kits but you don't really know if the right tool that you need is in them. It's worth a try. www.mcmelectronics.com. Best I can help you, I hope you find the tool. Tombstone
|
|
|
Post by mark4 on Oct 9, 2010 9:26:59 GMT -5
I have another tool. But I need to replace the one I normally use. It has the end that allows you to reach the bottom slug form the top. Thanks will check it out.
|
|