|
|
Post by harry on Sept 10, 2023 10:16:59 GMT -5
Going to rebuild My first Tram D201A, is there a parts list where i can get or copy. thanks
|
|
|
|
Post by brownbomber72 on Sept 11, 2023 18:09:26 GMT -5
I could use such a list myself
|
|
|
|
Post by 2600 on Sept 11, 2023 23:14:30 GMT -5
Our old list from decades ago is on here somewhere. It may have substitute parts shown, reflecting our stock. If I got a deal on a 2-Watt resistor twice the resistance called for in the circuit, we soldered two in parallel, to put a 4-Watt part where a 2-Watt factory resistor had overheated. Naturally the list evolved from the 80s to the 90s as our sources of closeout parts would themselves close forever. For the last 20-plus years we have used Xicon brand caps and resistors for the D201. Oddly enough, Mouser the distributor for that brand is now substituting other brands as their stock is depleted. Nothing lasts forever.
I should bring it up to date and post it here. No promises as to when.
A search on this forum's Browning/Tram section should turn one up, posted ten or more years back.
73
|
|
|
|
Post by bobcat4109 on Sept 12, 2023 13:46:43 GMT -5
Our old list from decades ago is on here somewhere. It may have substitute parts shown, reflecting our stock. If I got a deal on a 2-Watt resistor twice the resistance called for in the circuit, we soldered two in parallel, to put a 4-Watt part where a 2-Watt factory resistor had overheated. Naturally the list evolved from the 80s to the 90s as our sources of closeout parts would themselves close forever. For the last 20-plus years we have used Xicon brand caps and resistors for the D201. Oddly enough, Mouser the distributor for that brand is now substituting other brands as their stock is depleted. Nothing lasts forever. I should bring it up to date and post it here. No promises as to when. A search on this forum's Browning/Tram section should turn one up, posted ten or more years back. 73 I know that I, for one, would be grateful! Apparently,I learn something every day! In all the time I have known of you and seen you around, I didn't know you did this as a job! |
|
air1
Ratchet Jaw
Posts: 70
|
Post by air1 on Sept 13, 2023 8:48:19 GMT -5
|
|
|
|
Post by 2600 on Sept 13, 2023 23:00:54 GMT -5
Sure wish I knew who to thank for saving it as a PDF. And this is a newer version of the file that shows the parts we get from Mouser, not the quirky parallel combos from our 1990s parts stock.
73
|
|
air1
Ratchet Jaw
Posts: 70
|
Post by air1 on Sept 14, 2023 9:27:13 GMT -5
I took this copy from this group when it was posted a few years ago. Husker put a link to it back then. I have the copy that you originally put on here in 2005, but couldn't get it to load because of its size. I've seen both of them posted on a few of the Facebook groups.
|
|
