|
Post by Bus Driver on Sept 15, 2008 17:31:51 GMT -5
Hello All, I am looking for chnnl. mods.,and any other mods I can find on the President Madison, I did a search but had no luck. Thanks
|
|
|
Post by bioman on Sept 15, 2008 18:18:31 GMT -5
which board is in it??
there is several differnt channel mods depending on the board....
if you dont know which board it is whats the set-up on the radio??
we can figure it out from there...
president or uniden madison??
rotary clock or LED style?
does it have a "channel 9"button?
is the "PA" on the squelch knob?
scott
|
|
|
Post by Bus Driver on Sept 15, 2008 19:09:26 GMT -5
Scott, I havent got it yet,I know its a Uniden Madison thats all, Will get back at you when I get it. Thanks Bill
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 16, 2008 8:51:20 GMT -5
You are going to have to pull the cover and look at the PLL. It will be one of the ICs on the board. Write down the numbers, and post it here. Then we can help. If there is more than one, then post them all. We'll figure it out.
Not sure why you would want channel mods, as most were needed when the band was croweded. Nowadays, CB seem to hold more value if they are stock.
|
|
|
Post by Bus Driver on Sept 16, 2008 11:00:39 GMT -5
Thank You Scott and tick, I will try that again, would like to put 26.915 in it
|
|
|
Post by 2600 on Sept 16, 2008 16:06:10 GMT -5
Just look at the mike socket.
If it has 5 pins, you have the newer version with a MB8719 PLL chip.
If it's a 4-pin socket, you have the older version with the uPD858 PLL chip.
The mod you need will be determined by which PLL chip your version of this model has in it.
73
|
|