555
Ratchet Jaw
Posts: 68
|
Post by 555 on May 26, 2009 19:42:57 GMT -5
pulled the IV out the closet it was working when it was wrapped up and boxed
ok from what this guy says on the transformer the -12 volts is not working and tubes are little low
so can any tell me where to get a retube kit for my Mark IV
and where to get a replacement transformer
and something about the voltage reading causing the led channel readout to operate incorrectly.
i have a Eagle 500 tube amp yes i know its not made by browing or kenrich it just kinda blends in with the radio and it works just fine
also have a Mark III im very fond of and would like it checked out
|
|
|
Post by mark4 on May 27, 2009 16:31:38 GMT -5
555 sent you a message. Check your mail.
As for the Mark IV not having the right voltage. It may have a bad 4700uf cap or (2) 4400uf caps in parallel. (C5&C6). If the 11VDC supply is not working I would not suspect the transformer right off. Could be a blown internal fuse on the 11Volt supply and shorted rectifier bridge (D3). Also if it has no output the Display would not operate at all. Flickering display indicates a PLL out of lock condition. Causes can be many. But don't worry it can be fixed.
|
|